• Home
  • Equipment Orientation: Laser Cutter

Equipment Orientation: Laser Cutter

  • Wed, September 20, 2017
  • 7:00 PM - 9:00 PM
  • make717 Innovation Center
  • 0

Registration

  • Members in good standing may register for this class. Makers under 18 must be accompanied by an adult member.

Registration is closed

Learn to operate our Full Spectrum laser. The class covers safety, design issues, and operation of the hardware and software. The class requires the completion of a practicum. This is the class for new members and those who need to be re-certified.

This is a required orientation for anyone who wants to use the laser. You must be a member or a STEMPass holder in good standing to take the class. You must maintain your standing if you wish to have access to the laser.

You can review the documentation for the laser orientation online at https://wiki.make717.org/wiki/FullSpectrumLasercutter.

  • orientation.pdf is the official make717 laser manual.
  • supplement.pdf is a collection of forms used in daily operation of the laser. While most of these documents are provided in the laser area, you may need to print one from time to time.
In the past we had printed these files and handed them out at the class, but urge you to conserve paper and access them electronically.

Please no walk-ons. Class size is strictly limited due to time requirements. 

This session will be taught by Michael Dennis, LAMA.

Primetime hours for maker members
Mon - Fri: 5pm to 9pm
Saturday: 10am to 9pm
Sunday: 10am to 5pm


Copyright 2017 make717, Inc. All Rights Reserved 
Mailing Address:  1653 Lititz Pike #1213, Lancaster, PA 17601
Makerspace Address:  1151 Clark Street, Lancaster, PA 17602
(717) 537-1067 info@make717.org

Powered by Wild Apricot Membership Software